

ATmel ATTINY2313A-PU AVR Microcontroller IC 20MHz DIP-20
€ 3,70 incl. BTW
- Beschrijving
- Extra informatie
- Merk
- Downloads
- Q & A
Beschrijving
Informatie (ENG):
The high-performance Microchip picoPower AVR RISC-based CMOS 8-bit microcontroller combines 2KB flash memory, 128B EEPROM, 128B SRAM, 18 general purpose I/O lines, 32 general purpose working registers, a single-wire Interface for on-chip debugging, two flexible timer/counters with compare modes, internal and external interrupts,serial programmable USART, a universal serial interface (USI) with start condition detector, programmable watchdog timer with internal oscillator, and three software selectable power saving modes. The device operates between 18.8-5.5 volts. By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching 1 MIPS per MHz, balancing power consumption and processing speed.
Features
• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture– 120 Powerful Instructions – Most Single Clock Cycle Execution– 32 x 8 General Purpose Working Registers– Fully Static Operation– Up to 20 MIPS Throughput at 20 MHz
• Data and Non-volatile Program and Data Memories– 2/4K Bytes of In-System Self Programmable Flash
• Endurance 10,000 Write/Erase Cycles– 128/256 Bytes In-System Programmable EEPROM
• Endurance: 100,000 Write/Erase Cycles– 128/256 Bytes Internal SRAM– Programming Lock for Flash Program and EEPROM Data Security
• Peripheral Features– One 8-bit Timer/Counter with Separate Prescaler and Compare Mode– One 16-bit Timer/Counter with Separate Prescaler, Compare and Capture Modes–Four PWM Channels– On-chip Analog Comparator– Programmable Watchdog Timer with On-chip Oscillator– USI – Universal Serial Interface– Full Duplex USART
• Special Microcontroller Features– debugWIRE On-chip Debugging– In-System Programmable via SPI Port– External and Internal Interrupt Sources– Low-power Idle, Power-down, and Standby Modes– Enhanced Power-on Reset Circuit– Programmable Brown-out Detection Circuit– Internal Calibrated Oscillator
• I/O and Packages– 18 Programmable I/O Lines– 20-pin PDIP, 20-pin SOIC, 20-pad MLF/VQFN
• Operating Voltage– 1.8 – 5.5V
• Speed Grades– 0 – 4 MHz @ 1.8 – 5.5V– 0 – 10 MHz @ 2.7 – 5.5V– 0 – 20 MHz @ 4.5 – 5.5V
• Industrial Temperature Range: -40°C to +85°C
• Low Power Consumption– Active Mode
• 190 µA at 1.8V and 1MHz– Idle Mode
• 24 µA at 1.8V and 1MHz– Power-down Mode
• 0.1 µA at 1.8V and +25°C
Extra informatie
Gewicht | 50 g |
---|---|
Afmetingen | 2,5 × 1 × 1 mm |