- Beschrijving
- Extra informatie
- Q & A
Beschrijving
Informatie (eng):
The high-performance, low-power Microchip 8-bit AVR RISC-based microcontroller combines 16KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 16 general purpose I/O lines, 32 general purpose working registers, 8-bit timer/counter with compare modes, 8-bit high speed timer/counter, universal serial interface (USI), a LIN controller, internal and external interrupts, an 11-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, and three software selectable power saving modes. The device operates between 1.8-5.5 volts.
By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching 1 MIPS per MHz, balancing power consumption and processing speed.
1. Compatible with Arduino IDE 1.5 (OSX/Win/Linux)
2. Fully signed drivers and executable for easy installation
3. USB programming, USB device emulation, USB-CDC virtual serial port emulation
4. 16 MHz AVR MCU – using a true 16Mhz precision crystal
5. 16KB Flash Memory (14.5K+ after bootloader)
6. Serial over USB debugging and communication!
7. 14 i/o Pins (2 shared with USB)
8. I2C, true SPI, UART, LIN, and USI
9. ADC on 10 pins
10. 3 PWM Channels (which can be assigned to a selection of pins)
11. Power via USB, or External Source – 5v or 6-16v (automatic selection)
12. On-board button that can be used as a reset, program, or user button – or can be disabled to use that pin as general i/o – without changing the bootloader
13. On-board 150mA 5V regulator
14. Power LED and Test/Status LED (on Pin 1)
15. User accessible solder jumpers to disable LEDs, and other features for lower power consumption
16. Two mounting holes.
17. Breadboard compatible pin out/spacing (the three side header pins are only for legacy shield support).
Extra informatie
| Gewicht | 100 g |
|---|---|
| Afmetingen | 2 × 2,5 × 0,3 mm |
| Voltage (V) | |
| Chip | |
| Model | |
| Connector | |
| Spanningsregelaar onboard | |
| Geschikt voor Breadbord |
