Display LCD 84×48 pixels 1.6″ rood PCD8544

Beschrijving

Wordt geleverd met headerpins 1×8

Note:

– LIGHT linked with GND, the backlight to be lit.

– Check and compress the screen and PCB tighter, might got loose after the delivery.

– Use a 3.3V controller, otherwise the display could be quite vague.

–  There may be small blemishes on these screens as they are surplus.
–  Your screen may or may not have a diode on the PCB. It does not affect performance and will vary depending on our shipment.

LCD5110 Module:

Power supply voltage: 2.7V-3.3V,5V is OK,but part of the screen becomes black when tested

Data interface level: 2.7-5V

Backlight power supply voltage: highest 3.3V

Module size: 43.6mm x 43.1mm(width X height)

Installation diameter: 2mm

Backlight: White

– RST——— reset

– CE————chip selection

– DC———–data/commands choice

– DIN———–serial data line?

– CLK————serial Clock

– 3.3V————VCC

– LIGHT——— backlight control terminal

– GND———–power negative

Features

– 84 X 84 dot matrix LCD,can show 4 lines of characters

– Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.

– Can use the conductive glue to connect the module with the printed board,without connecting cable.The metal hooks on the module can fix the module on the printed board,which is very easy to install and replace.

– LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small

– Low power supply,the working current in normal situation is lower than 200μA,and has power-down mode

Extra informatie

Gewicht	100 g
Afmetingen	5 × 5 × 2 mm

Please login to post questions