USB-A naar serieel TTL/UART met PL2303HXA chip

Beschrijving

Informatie (ENG)

• Windows 8/8.1/10 are NOT supported in PL-2303HXA and PL-2303X EOL chip versions.
• Run PL2303 CheckChipVersion tool program in Windows XP/Vista/7 to check chip version.
• Windows Vista, XP, 2000, 98 and Windows ME driver technical support are discontinued.

Volg deze instructie om de PL2303HXA chip alsnog op windows 10 te gebruiken:

Om deze stick te gebruiken op windows 10 moet men een driver versie gebruiken kleiner dan v3.4
Installeer de 3.3 drivers (zie downloads), en na installatie selecteer via apparaatbeheer de v3.3 van het stuurprogramma.

Instructie: http://domoticx.com/pl2303-usb-to-uart-bridge-drivers-windows/

Let op: de pinout op de stick kan afwijken van getoonde foto, kijk daarom altijd op de achterkant wat de pinout is.

Description:
– Adopt imported controller PL2303HX,which can stabilize the flash with high speed
– 500mA self recovery fuse for protection
– Two data transmission indicator can monitor data transfer status in real time
– Reserve 3.3V and 5V pin interface,easy for the DDWRT of different voltage system that need power
– The entire board is coated by high quality transparent heat-shrinkable sleeve,making the PCB in insulation state from outside, so that the board won’t burnt down by material short cut.
– Electrostatic package,insures the board will not be damaged before use
– Support WIN7 system

Application:
All kinds of satellites set-top box upgrade Router,HDD,ADSL,broad band modem firmware upgrade or cracked upgrade cellphone,XBOX360,GPS serial communication,vehicle inspection and test,DVD flash and so on
Burn write STC MCU,NXP MCU,renesas MCU,NEC MCU and so on
Simple UART communication,commonly used UART debugging tools in supper terminal
USB signal transferred to TTL signal,may be used by electronic enthusiasts