Moederbord READY-TO-GO Socket Slot 1 2xSD-RAM 3xPCI 1xISA MicroATX 20-pins / MSI MS-6147 REV1.1(C) MET I/O SHIELD

Beschrijving

Dit is een 2e KANS/Retro artikel/product, en is getest op werking/functionaliteit!

— GARANTIE 14 dagen na aankoop —

Opmerkingen:
– Getest en werkend.
– Wordt geleverd met nieuwe CR2032 batterij.
– Wordt geleverd met I/O shield indien van toepassing (tenzij anders vermeld)
– Wordt geleverd met processor koeler/heatsink indien van toepassing (tenzij anders vermeld)
– Alleen moederbord, dwz, wordt zonder processor, werkgeheugen, doos, kabels of CD (drivers) geleverd.
– Drivers zijn eventueel hier te downloaden: Drivers downloaden
– Lees onderstaande informatie goed door kwa ondersteuning processor, geheugen, etc.
——————————————

READY-TO-GO:

• Intel Pentium III 600 MHz (nieuwe koeler)
• 128MB SD-RAM 133Mhz

• Heeft onboard Video (ATi 3D Rage Pro PCI)

Also known as:

• Packard Bell Tempest
• Premio 212J
• Premio BX2
• MSI BX7
• Time / Tiny (unknown model) system board

Notes:

Revision C supports Coppermine Pentium III

Notes on the PB version:
There are a couple of jumpers that disconnect one of the two rear USB ports and connects it to an internal header, which can then be used for a front panel USB port.

J16 is a 6 pin header between PCI slots 2&3. If jumpered 2-3 and 5-6 then both rear USB ports are connected. If jumpers 1-2 and 4-5 then USB is on J15 (next to the other front panel connector JFP).
J15 is a 10 pin header with 2 pins missing and 2 pins that seem to be not connected to anything. There are 3 Ground pins, 1 +5V pin and the USB D- and D+ pins.

. o GND
D- o o GND
D+ o o N/C?
. o GND
+5V o o N/C?
There are also several missing headers, such as fan headers (other than the CPU fan), the temperature sensor and keyboard power on.

The larger capacitors had all failed so replace everything above 470uF (15 capacitors in total).

Interestingly, some SDRAM that I’d modded from registered to just buffered, which works fine in a Via Slot A board, doesn’t work. I suspect something is actually checking the SPD and deciding to not to try using it.

Installing W98 worked with no problems. W2k had a problem with using the AGP port. It claimed it couldn’t find enough free resources to use it, but also had no resource conflicts. Changing the PC type to standard from ACPI fixed the problem. I’d guess a problem with the ACPI stuff in the BIOS maybe? The BIOS version is 2.0 and there is a 2.1 version which I haven’t tried.

Meer informatie: https://theretroweb.com/motherboards/s/msi-ms-6147-bx7