Stroommeter module DC 60V max. analoog 0.1 Ohm Shunt load 10K Ohm (default) INA169 blauw

 4,57 incl. BTW

Availability: 19 op voorraad Artikelnummer: SEN-2xxx-IN169B Categorie: Tags: , , , , , ,
Vergelijken

Beschrijving

Introduction

GY-169 is a simple current converter for current measuring up to 5A. It incorporates the INA169 chip delivered by Burr-Brown from Texas Instruments, which intensifies the voltage read by a little shunt and gives a voltage yield relative to the deliberate current. The 0.1 ohms, 2W resistor permits an exact current estimation up to 5A with a 1V proportion for every Ampere. You can just interface the module with the microcontroller to control or monitor the current of any device.

Gy-169/ INA169 Board Overview

The breakout board comprises a shunt resistor, the INA169 chip, and a load resistor. While shunt and load may seem to have two resistors, just one is inhabited on the board. Assuming you might want to change the values of the resistors, you can change them by putting different values of resistors in parallel.

Working of Module

As current goes from VIN+ through the shunt resistor to VIN-, it makes a voltage drop across the shunt. The operation amplifier within the INA169 chip estimates the difference between the VIN+ and VIN-voltages and provides results based on that. It amplifies the output through the inside transistor, which sources a current out of the INA169 chip. As that current goes through RL to the ground, it generated a voltage level at VOUT.

Features and Specifications of Gy-169/ INA169

Features

  • Complete Unipolar High-Side Current
  • Measurement Circuit
  • Wide Supply and Common-Mode Range
  • Independent Supply and Input Common-Mode Voltages
  • Single Resistor Gain Set
  • Low Quiescent Current
  • 5-Pin, SOT-23 Packages
  • Number of channels: 1
  • Comparators : 0


Specifications

Operating temperature range: (C)-40 to 125

Chip: INA169

Shunt resistor 0.1 ohm 1% 2W

Supply voltage: 2.7 ⁓60 V

Current measurement up to + 5A

Output: 1V for each Ampere measured

Common mode voltage (Max): 60V

Common mode voltage (Min): 2.7V

Input offset (+/-) (Max): 1000uV

Input offset drift (+/-):1uV/C

Gain: Adjustable

Gain error: 2%

Bandwidth: (kHz)440

Iq (Max): 0.125mA

Pin NameDescription
VccSupply power to the module needs to be connected to 3.3V, 5V, etc. This can be anywhere from 0 to 60V
GNDThe ground. Should be connected to the ground.
VIN+ Positive input voltage. Needs to be connected to the positive side of the supply
VIN-Negative input voltage.
OUTOutput current

Extra informatie

Gewicht 10 g
Afmetingen 2 × 2 × 1 mm
Please login to post questions